Shopping Cart
Shopping cart is empty.

Suggested

Suggested

  • Power Box
    • Power Box
    • $395.00
    • Affordable and simple answer to those anoying wiring issues. The powerbox is a replacement for that troublesome fuse box & the relay box that has loose terminals or even corroded from moisture. Power box is a solution for all of those problems, having 2.5 mt of battery cable to supply a good power supply to all of your projects requirements such as fuel pumps, thermo fans and injectors. With 2 x 30 amp outputs it is designed to control most of your project.
      The power box has been designed to take all the rough treatment with a resetting system. If you have a fault in your wiring or a faulty part, the power box has 6 diagnostic lights that will light up and stop current to that component for a nominated time. After this it will then retry to power the device up. As there are no replacable relays or fuses the power box can be used under water, making this unit perfect for Boats and 4X4.
      All outputs are controllable via 6 low energy inputs this means most ECU's switching can control them or as simple as a switch on the dash.

      Features

      • 1 x 10 amp output
      • 3 x 20 amp outputs
      • 2 x 30 amp outputs
      • 2.5mt duel core battery cable
      • 5 x low side switched inputs
      • 1 x high side switched input
      • All connectors are weather proof
      • L=113mm x W=54mm x H=23mm
    • Read More
  • EGT probe
    • EGT probe
    • $115.00
    • Applications: ? Motor Sports ? Marine ? Aviation ? Power Gen ? Research & Development ? Alternative Energy ? Military The Exhaust Gas Temperature Sensor is specifically designed for use in racing, tuning, and testing applications. Made in the USA from superior materials. The Exposed Tip sensing junction provides immediate response to dynamic temperature changes. The Exhaust Gas Temperature Probe is capable of surviving extreme vibration and heat up to 2300 degrees F (1300 degrees C). The EGT probe will fit most internal combustion engine exhaust systems from approximately .750 inch diameter up to about 4 inch diameter with nominal installation modifications. The EGT probe is 0.187" diameter (4.75 mm) with a 90-degree bend to accommodate tight mounting locations. An adjustable (316 Stainless Steel) 1/8" NPT compression fitting adapter is included. The EGT probe cable lead length is 6 feet (1.8 meters). The probe cable is over-braided in stainless steel for heavy-duty abrasion resistance. The signal wires are Teflon insulated. Designed to deliver high performance, high temperature measurements, reliably and consistently. These high temperature sensors are the choice for professional racing teams, R&D test labs, and enthusiasts. The EGT probes can be used for many different applications, including? but not limited to? Karts, Drag Racing, Formula 1, NASCAR, Off Road, Snowmobiles, Aviation, and Marine Racing.
    • Read More
  • EGT Bung
    • EGT Bung
    • $12.00
    • This weld in bung is made from steel, it has an internal thread of 1/8 NPT .
      The outside is 12mm with a tapper to a ridge. this design makes it easy for instillation in car.
      By drilling a 12mm hole in your exhaust you can then tap the bung in and the tapper will hold it in place while you weld it.

    • Read More
  • Air Temp Sensor
    • Air Temp Sensor
    • $35.91
    • This universal airtemp sensor is compatable with all Wolf ECU's.
      having a bosch style connector makes it very easy for installation.
      Thread size 14mm x 1.5mm
    • Read More
  • Water Temp Sensor
    • Water Temp Sensor
    • $24.91
    • Universal water temperature sensor,
      This sensor will work with most Wolf ECUs.
      Having a Bosch style injector plug makes the insterlation of this sensor easy.
      thread size 12mm x 1.25mm
    • Read More
    • Mitsubishi / Hyandui Igniter
    • $85.00
    • single channel igniter
      used in cases were you may need to use an igniter to fire a coil, compatable with all Wolf ECU,s.
      This OEM style igniter is rated at 7amp and 3.2ms dwell
    • Read More
  • Air temp Plug Kit Bosch
    • Air temp Plug Kit Bosch
    • $11.36
    • Bosch style injector plug kit. Kit contains: 1 x Injector plug 2 x injector pins 1 x injector boot

    • Read More
  • 3 Pin Igniter Plug Kit
    • 3 Pin Igniter Plug Kit
    • $21.00
    • 3 Pin igniter plug, suits Hyundai/Mitsubishi single channel igniter.

    • Read More
  • Delco TPOs Connector
    • Delco TPOs Connector
    • $8.82
    • Delco TPOS Connector kit , This Kit contains the plug and pins required to fit this connector up. Note when fitting up this connector the wires push through the connector and then you crimp the terminals on to it and pull back into the connector

    • Read More
    • Dual channel igniter
    • $200.00
    • Dual channel igniter ,

      This Igniter "amplifier" can be used with OEM or aftermarket coils (coils that have do not have built in igniters)

      Comes with seven pin plug ass and heatsink


    • Read More
  • Injector Plug Kit Bosch
    • Injector Plug Kit Bosch
    • $11.36
    • Bosch style plug kit. Kit contains: 1 x Injector plug 2 x injector pins 1 x injector boot

    • Read More
  • K type Thermocouple connector
    • K type Thermocouple connector
    • $28.50
    • 2 Pin male K-type connector , suits K-type Exhaust Gas Temperature sensors and K-type thermocouples.

    • Read More
  • Racepak Wolf Vnet cable
    • Racepak Wolf Vnet cable
    • $695.00
    • When using a Racepak IQ3 dash you can interface directly with Wolf Via the V-Net cable, This interface allows such data to be displayed as:

      RPM
      Engine Temperature
      Air Temperature
      Throttle Position
      Boost
      Speed
      Air / fuel ratio
      Internal MAP Sensor
      Auxilaries LS 1-4
      Multicontrollers 1-2
    • Read More
    • single channel Igniter
    • $88.00
    • Single channel igniter designed for instillation with single coil drivers

      This igniter is a 7amp igniter small in size .

    • Read More
    • Triple channel igniter
    • $255.20
    • Triple channel igniter ,

      This Igniter "amplifier" can be used with OEM or aftermarket coils (coils that have do not have built in igniters)

      Comes with seven pin plug ass and heatsink

       

    • Read More
  • USB Adapter
    • USB Adapter
    • $99.00
    • This adapter allows for connection between 9 pin serial plugs and a USB connector. This unit is of high quality and speed rate. When using the Wolf software we guarantee this product to work faultlessly and at very high refresh speed rate. This unit is compatible with Windows 98,Vista,2000,XP,windows 7,8,8.1.

    • Read More
  • Water Plug Kit Bosch
    • Water Plug Kit Bosch
    • $11.36
    • Bosch style plug kit. Kit contains: 1 x Injector plug 2 x injector pins 1 x injector boot

    • Read More

Login to Wolf EMS

Your browser is out-of-date!

Update your browser to view this website correctly. Update my browser now

×